How to solve the problem of electric hoist and how to install busbar

Lifting equipments are widely used in various industries, because most of the time some heavy human cannot be transport, if forced transportation will also be a danger, the emergence of the lifting equipment, can be very good to solve this problem, the electric hoist is one of the many lifting equipments, how to solve this kind of equipment failure?How to install the slip line?We read in detail.

Electric hoist malfunction solution:

During the period of use of equipment failure is very common, when fault occurs when you need to solve in time, first check the equipment to see if the power of the fuse is burned, if burn out a phase, equipment can only single-phase motor starting, starting torque is zero, the motor cannot turn, need to change the fuse of the power supply.

If the power grid voltage is too low, can also cause equipment malfunction, this time to launch torque and voltage is proportional to the square, accelerating torque, if can’t overcome the load torque will not run speed, this time should be appropriate to improve power grid voltage.Stator winding and short circuit, grounding or short circuit will make the device appear problem, when the winding grounding, yao o blow open the junction box is checked, when short circuit should not only check the motor, also check control equipment wiring is correct, when necessary to replace the contactor.

Electric hoist busbar installation method:

In many cases, this equipment will be installed above the u-shaped track, in view of this characteristic, can decorate the wire in the middle of the track, beams above, rope, wire rope need to use 10 mm head bolt, attention should be paid toSlip ring must be two circle corner, there is a certain margin, so that you can avoid wire scratches and caton case, turned to the ring to the two rings together with bolt, it can make turning more freedom.

If equipment installed in the outside, and pay attention to the construction of rainproof facility, often should maintain the dry degree of the equipment, the operation is completed, to make the device away from the wet area, high temperature or chemical area, it can ensure that the overall performance of the equipment.

Actually both electric hoist fault solution and installation methods, their ultimate goal is to ensure that equipment eventually use effect, effective after installation can ensure normal and effective operation, the equipment the most professional advantage into play, failure occurs and effective to solve, can not waste time, to increase efficiency.